Anaheim H300 Manual do Utilizador descarregar pdf (Página 9)

7. Press the “ REC Button” (4-4, Fig.1) momentarily to start the data log function. The REC

symbol will be displayed on the LCD. The data logger function can save up to 1000 values of

measure (either Humidity & Temp. or Dew Point & Te mp).

8. Press the “Logger Button” (4-6, Fig.1) and the meter will start logging. You will see the A

flashing on the top of the LCD every time a logging event has occurred. The A flashing will

match the number of seconds you set in the setup of the data logger function.

9. If the A in the top of the LCD and the lower display are flashing then, it indicates that the

memory is full. Please view the “ Clears the existing saving data from the memory” section in

the “ Advanced Measuring Procedures” section.

4-8 Manual Data Logger (set sample time to 0 seconds)

1. Press the “ REC Button” (4-4, Fig.1) momentarily to start the data log function. The REC

symbol will be displayed on the LCD. The data logger function can save up to 1000 values of

measure (either Humidity & Temp. or Dew Point & Te mp).

2. Press the “Logger Button” (4-6, Fig.1) every time you would like the meter to record a value.

You will see an A flash in the top of the LCD. The meter willnot record another measurement

until you press the “Logger Button” (4-6, Fig.1) again.

3. If the A in the top of the LCD and the lower display are flashing then, it indicates that the

memory is full. Please view the “ Clears the existing saving data from the memory” section in

the “ Advanced Measuring Procedures” section.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Anaheim H300 Manual do Utilizador Página 9